Configure driver codes

Configure Driver Codes

Use the Driver Codes driver to assign the default global driver statistics for all forecast groups.

You can also make exceptions by Forecast Group. Only those statistics available on the Drivers tab may be used as a driver statistic.

To configure driver codes:

  1. In the RF Admin task pane, in the Setup section, double-click Drivers.
  2. If needed, change the selected scenario.
  3. Select the Code Mapping tab, and then click the Driver Codes subtab.

  4. Complete the following selections as needed:

    Option Instructions
    Global Default Drivers

    For RF Group, from the IP Driver, OP Driver, and Other Driver drop-downs, select the default calendar-based assumption.
    RF Plan Group Exceptions
    1. To add an exception to the default plan group settings for an RF Plan Group, click + Insert New RF Plan Group Exception.
    2. From the RF Plan Group drop-down, select the plan group.
    3. From the IP Driver, OP Driver, and Other Driver drop-downs, select the options for the exception.
    RF Group Exceptions
    1. To add an exception to the default settings for an RF Group, click + Insert New RF Group Exception.
    2. From the RF Group drop-down, select the RF Group exception.
    3. From the IP Driver, OP Driver, and Other Driver drop-downs, select the options for the exception.
  5. To delete an exception, select the checkbox in the delete column. The code is deleted after you click Save.
  6. To save your changes, in the upper right corner of the page, click Save, and then, in the confirmation dialog, click OK.